International Peer-Reviewed Journal•Open Access•ISSN 2456-8880
irejournals@gmail.com•+91-7433024337

Home / Current Issue / Paper 1700609

1700609 Vol 1 · Issue 10 Download Paper

Power Quality Improvement Using Closed Loop Dc-dc Converter

Mohammad Amir Ansari Ashutosh Yadav Ashish Singhal

Subject area: Science,Engineering and Technology  ·  Area of research: Electrical engineering

Abstract

This paper presents a study on utilization of DC-DC converter in the renewable energy system like wind turbine. Basically all DC-DC converters are based on two models i.e. Buck and Boost. The aim here to use DC-DC converters is to reduce the size, cost and losses. In the present scenario we need power of better quality i.e. noise, ripple content and harmonics should be as minimum as possible. These aims can be better satisfied by using DC-DC converters. Higher efficiency of DC-Dc converters makes it extremely useful in modern energy conversion systems.

Keywords

DC-DC converter, MATLAB, Voltage Control

References

[1] Pradipta Patra, Amit Patra, and Neeraj Misra, “A Single-Inductor Multiple-Output Switcher With Simultaneous Buck, Boost, and Inverted Outputs,” IEEE Trans. on Power Electron., vol. 27, no. 4, pp.1936-1951, April 2012.

[2] Shih-Ming Chen, Lung-Sheng Yang, Tsorng- Juu Liang, and Jiann-Fuh Chen, “A Cascaded High Step-Up DC-DC Converter With Single Switch for Microsource Applications,” IEEE Trans. on Power Electron., vol. 26, no. 4, pp.1146-1153, April 2011.

[3] Chuan Yao; Xinbo Ruan; Xuehua Wang; , "Isolated Buck-Boost DC/DC converter for PV grid-connected system," Industrial Electronics (ISIE), 2010 IEEE International Symposium on , vol., no., pp.889-894, 4-7 July 2010.

[4] Tan, N.M.L.; Abe, T.; Akagi, H.; , "Design and Performance of a Bidirectional Isolated DC–DC Converter for a Battery Energy Storage System," Power Electronics, IEEE Transactions on , vol.27, no.3, pp.1237-1248, March 2012.

[5] F. Blaabjerg, Z. Chen, and S. B. Kjaer, “Power electronics as efficient interface in dispersed power generation systems,” IEEE Trans. Power Electron., vol. 19, no. 5,pp. 1184–1194, Sep. 2004.

[6] Matsuo, Hirofumi; Kurokawa, Fujio; , "New Solar Cell Power Supply System Using a Boost Type Bi directinal DC-DC Converter," Industrial Electronics, IEEE Transactions on , vol.IE-31, no.1, pp.51- 55, Feb. 1984.

[7] S. Cuk, Basics of switched-mode power conversion: topologies, magnetics, and control, in Advances in Switched-Mode Power Conversion, vol. 2, pp. 279-310, Irvine: Tesla co, 1981.

[8] R. W. Erickson, Fundamentals of Power Electronics NewYork: Chapman and Hall, 1997.

[9] V. Vorperian, R. Tymerski, and F. C. Lee, Equivalent circuit models for resonant and PWMswitches, IEEE Trans. Power Electron., vol. 4, no. 2, pp. 205-214, April 1989.

[10] G. W. Wester and R. D. Middle brook, Low frequency characterization of switched dc-dc converters, IEEE Trans. Aerosp. Electron. Syst., vol. AES-9, pp. 376-385, May 1973.

[11] Moshirvaziri, M.; Chuanwei Li; Trescases, O.; , "A quasi-resonant bi-directional tri- mode DC-DC converter with limited valley current," Applied Power Electronics Conference and Exposition (APEC), 2012 Twenty-Seventh Annual IEEE , vol., no., pp.517-523, 5-9 Feb. 2012.

[12] Kuiyuan Wu; de Silva, C.W.; Dunford, W.G.; "Stability Analysis of Isolated Bidirectional Dual Active Full-Bridge DC–DC Converter With Triple Phase-Shift Control," Power Electronics, IEEE Transactions on , vol.27, no.4, pp.2007-2017, April 2012.

[13] Stahl, G.; Rodriguez, M.; Maksimovic, D.; , "A high-efficiency bidirectional buck-boost DC-DC converter," Applied Power Electronics Conference and Exposition (APEC), 2012 Twenty-Seventh Annual IEEE , vol., no., pp.1362-1367, 5-9 Feb 2012.

[14] Yu Du; Huang, A.Q.; Mengqi Wang; Lukic, S.M.; , "A novel high step-up ratio bi- directional DC-DC converter," Applied Power Electronics Conference and Exposition (APEC), 2012 Twenty-Seventh Annual IEEE , vol., no., pp.524-531, 5-9 Feb 2012.

How to cite this paper

Mohammad Amir Ansari, Ashutosh Yadav, Ashish Singhal "Power Quality Improvement Using Closed Loop Dc-dc Converter" Iconic Research And Engineering Journals Volume 1 Issue 10 2018 Page 127-131
Mohammad Amir Ansari, Ashutosh Yadav, Ashish Singhal "Power Quality Improvement Using Closed Loop Dc-dc Converter" Iconic Research And Engineering Journals, vol. 1, no. 10, Apr. 2018
Mohammad Amir Ansari, Ashutosh Yadav, Ashish Singhal (2018). Power Quality Improvement Using Closed Loop Dc-dc Converter. Iconic Research And Engineering Journals, 1(10).
Mohammad Amir Ansari, Ashutosh Yadav, Ashish Singhal "Power Quality Improvement Using Closed Loop Dc-dc Converter" Iconic Research And Engineering Journals, vol. 1, no. 10, Apr. 2018.
@article{1700609,
      author = {Mohammad Amir Ansari, Ashutosh Yadav, Ashish Singhal},
      title = {Power Quality Improvement Using Closed Loop Dc-dc Converter},
      journal = {Iconic Research And Engineering Journals},
      year = {2018},
      volume = {1},
      number = {10},
      pages = {127-131},
      issn = {2456-8880},
      url = {https://www.irejournals.com/formatedpaper/1700609.pdf},
      abstract = {This paper presents a study on utilization of DC-DC converter in the renewable energy system like wind turbine. Basically all DC-DC converters are based on two models i.e. Buck and Boost. The aim here to use DC-DC converters is to reduce the size, cost and losses.
In the present scenario we need power of better quality i.e. noise, ripple content and harmonics should be as minimum as possible. These aims can be better satisfied by using DC-DC converters. Higher efficiency of DC-Dc converters makes it extremely useful in modern energy conversion systems.
},
      keywords = {DC-DC converter, MATLAB, Voltage Control},
      month = {April},
  }