Abstract
The main aim of this research paper deals with the design of spindle for 2-axis CNC lathe machine. The spindle axis is horizontal in lathe machine. The speed of spindle can be set with levers and pulley belts to give a range of speed. Especially, spindle assembly involves design of shaft diameter, spur gear, selection of bearing and keyway. The shaft is made with commercial steel and speed is 1500 rpm. The length of the shaft is 1000 mm and outside and inside diameter of shaft are 86mm and 60.2mm. In spur gear design, pinion and gear are made with cast iron. Module and face width of the spur gear are 5mm and 63mm. The dynamic force, wear force and endurance force of the spur gear are 5751.628N, 25512.820N and 7565.505N.
Keywords
spindle, CNC Lathe, shaft, module, face width
Citations
IRE Journals:
Arkar Htun , Ei Ei Thar , Phyo Min Than
"Design And Calculation Of 2-Axis CNC Lathe Machine (Spindle And Shaft)" Iconic Research And Engineering Journals Volume 3 Issue 2 2019 Page 97-102
IEEE:
Arkar Htun , Ei Ei Thar , Phyo Min Than
"Design And Calculation Of 2-Axis CNC Lathe Machine (Spindle And Shaft)" Iconic Research And Engineering Journals, 3(2)
About IRE Journals
IRE Journals is an open access online journals established with an aim to publish high quality of research work in various diciplines. We have more than 6 years in publications. Over 2500+ papers already published.
Important Links
For Authors
Volume 6:
Issue 1, Issue 2, Issue 3, Issue 4, Issue 5, Issue 6, Issue 7, Issue 8, Issue 9, Issue 10, Issue 11, Issue 12Volume 5:
Issue 1, Issue 2, Issue 3, Issue 4, Issue 5, Issue 6, Issue 7, Issue 8, Issue 9, Issue 10, Issue 11, Issue 12Volume 4:
Issue 1, Issue 2, Issue 3, Issue 4, Issue 5, Issue 6, Issue 7, Issue 8, Issue 9, Issue 10, Issue 11, Issue 12Volume 3:
Issue 1, Issue 2, Issue 3, Issue 4, Issue 5, Issue 6, Issue 7, Issue 8, Issue 9, Issue 10, Issue 11, Issue 12